The machining process of the edge inspection vibration knife integrated machine can be summarized as the following steps:
1. Prepare the workpiece and fixture, and place the parts to be cut in a fixed position on the machine tool. Prepare tools, measuring tools, and other auxiliary equipment at the same time. 2. Preheat the machine and adjust the frequency of the piezoelectric ceramic oscillator to around 30-45Hz and stabilize it. Start the spindle motor to minimize the gap between the grinding wheel and the liner plate to reduce noise and spark interference. Run empty for a few minutes within the set travel range to ensure there are no abnormal situations before starting the operation. Be careful not to apply too much force to avoid causing artificial faults; After entering the normal working state, adjust each part according to the regulations of the process card; During operation, the upper and lower limits can be adjusted according to the specific situation, and non-standard equipment can be customized to meet the requirements and ensure consistent cutting quality and high product size; Compared with manual control, time relays can effectively avoid unnecessary troubles caused by operator errors, such as timely resetting with a handle when cutting off power, to ensure a smooth production process.
The above information is for reference only. If you have any further questions, please consult a professional for advice.
- Precautions for cleaning the side hole machine
- Operation process of vibration engraving machine
- Operation process of automobile mold machine
- Common knowledge of edge inspection vibration knife integrated machine
- Precautions for cleaning the edge inspection vibrating knife integrated machine
- Common knowledge of side hole machine
- Integrated machining process of edge inspection vibration knife