Pressure tapping machine is a device used for tapping holes under pressure, suitable for various pipelines and containers. The following are general instructions for the pressurized drilling machine:
Before use, check if the equipment is intact, if all components are installed correctly, and if the power supply is functioning properly.
Before performing the drilling operation, the valve of the pipeline or container should be closed first to prevent gas or liquid leakage.
3. Choose appropriate drilling tools as needed, including drill bits, cutting blades, etc.
4. Install the drilling tool on the equipment and adjust its position and angle.
Before starting drilling, a trial drill should be conducted to ensure that the equipment is working properly.
When drilling, pressure should be applied slowly and steadily to avoid equipment damage or personnel injury caused by too fast or too strong pressure.
After the opening is completed, the equipment should be immediately turned off and the opening should be checked for compliance with the requirements.
After use, the equipment should be cleaned thoroughly and stored in a dry and ventilated place.
It should be noted that when using a pressurized drilling machine, safety operating procedures should be followed to ensure the safety of personnel and equipment.
- Common knowledge of vibration engraving machine
- Automotive mold machining process
- Introduction to vibration engraving machine
- Introduction to Advertising Carving Machine
- What should be noted for advertising engraving machines
- What should be noted for automotive mold machines
- Common knowledge of side hole machine